APPLICATION AND USE
Preparation
PREVIOUSLY PAINTED SURFACE: In Good Condition: Wash down with a suitable detergent, rinse with fresh water and allow to dry. Abrade with 280 320 grade (grit) paper. Remove sanding residue. Wipe with Brushing Liquid 333 and allow to dry completely.
In Poor Condition: Remove all previous coatings and prime the substrate.
PRIMING: Please refer to the primer or primer/undercoat technical datasheet.
ALL SUBSTRATES: Prime with a suitable primer or primer/undercoat (PreKote Plus/Epoxy Primekote).
Method
Sand the undercoat smooth with 320400 grade (grit) wet or dry paper. Remove dust with a dust wipe. Apply 2-3 coats of Toplac Plus.
Hints
Mixing: Stir well before use.
Thinner: Reducing Solvent (Y2333N) Brush or Special Thinner 216 (Y216) Spray.
Thinning: Add 10% Reducing SolventBrush (Y2333N) to ease the application by brush/roller. The thinner quantity can be adjusted with climate conditions. At temperature above 75°F (25°C) an extra 5% Reducing Solvent (Y2333N) should be added.
Cleaner: Brushing Liquid 333, Reducing Solvent (Y2333N) Brush or Special Thinner 216 (Y216) Spray.
Ventilation and Humidity Control: Apply in dry, well ventilated conditions.
Some Important Points
Toplac Plus may discolor if used a temperatures above 80°C/176°F. Not suitable for permanently immersed surfaces. Do not use below 5°C/41°F.
Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F.
Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F.
Product temperature should be minimum 15°C/59°F and maximum 35°C/95°F.
